Vulnerability · CVE-2022-34151
omron nx701-1600_firmware Use of Hard-coded Credentials
Published Aug 13, 2022 · corrected/updated Aug 13, 2022 · omron nx701-1600_firmware · evidence confidence very high
Use of hard-coded credentials vulnerability exists in Machine automation controller NJ series all models V 1.48 and earlier, Machine automation controller NX7 series all models V1.28 and earlier, Machine automation controller NX1 series all models V1.48 and earlier, Automation software 'Sysmac Studio' all models V1.49 and earlier, and Programmable Terminal (PT) NA series NA5-15W/NA5-12W/NA5-9W/NA5-7W models Runtime V1.15 and earlier, which may allow a remote attacker who successfully obtained the user credentials by analyzing the affected product to access the controller.
Grounded briefings
Catalog interpretations for three audiences. Each brief cites ingested metadata and the original advisories below. They are not independent research and they do not invent exploit steps.
Executive
CVE-2022-34151 is a unknown public vulnerability record for omron nx701-1600_firmware. CISA lists it as known exploited. Published remediation guidance: Apply remediations or mitigations per vendor instructions or discontinue use of the product if remediation or mitigations are unavailable. This summary is a catalog interpretation of the ingested metadata and cites the original advisories below.
System administrator
Identify whether omron nx701-1600_firmware is in your estate, then compare installed versions with the affected ranges. Affected packages or ranges on record: omron nx701-1600_firmware. Published remediation guidance: Apply remediations or mitigations per vendor instructions or discontinue use of the product if remediation or mitigations are unavailable. Prefer the vendor or distribution advisory linked in Sources before changing production systems. This is a catalog interpretation, not a runbook.
Security analyst
Signals on file: no CVSS/EPSS yet. CISA lists it as known exploited. Sources contributing to this record: vulncheck_kev. Public exploit references, when present, are outbound links only and are not proof of active exploitation. This is a catalog interpretation of stored metadata.
Exploitation and remediation
Exploitation evidence
Confirmed in CISA KEV since Aug 13, 2022. Listed in CISA KEV and VulnCheck KEV.
Patch and remediation
Apply remediations or mitigations per vendor instructions or discontinue use of the product if remediation or mitigations are unavailable.
Safe detection guidance
Compare installed versions with the affected ranges below and verify the advisory from the original publisher. This site stores metadata and outbound links only; it does not ship exploit code or proof-of-concept payloads.
Code
The project this record applies to. Exploit listings stay in References.
No public source repository is identified for this product.
Timeline
Detection, updates, and resolution for this record.
Aug 13, 2022 · VulnCheck KEV
Detected
Use of hard-coded credentials vulnerability exists in Machine automation controller NJ series all models V 1.48 and earlier, Machine automation controller NX7 series all models V1.28 and earlier, Machine automation controller NX1 series all models V1.48 and earlier, Automation software 'Sysmac Studio' all models V1.49 and earlier, and Programmable Terminal (PT) NA series NA5-15W/NA5-12W/NA5-9W/NA5
Aug 13, 2022 · CISA KEV
Known exploited
Apply remediations or mitigations per vendor instructions or discontinue use of the product if remediation or mitigations are unavailable.
Affected
- vendor omron nx701-1600_firmwareversion unspecified
Sources
- VulnCheck KEVConfirmed exploitationCVE-2022-34151
Use of hard-coded credentials vulnerability exists in Machine automation controller NJ series all models V 1.48 and earlier, Machine automation controller NX7 series all models V1.28 and earlier, Machine automation controller NX1 series all models V1.48 and earlier, Automation so
vulncheck.com