Vulnerabilities

Vulnerability · CVE-2026-19936

The Bluetooth Mesh Access-layer delayable message queue in subsys/bluetooth/mesh/delayable_msg.c shares three intrusive lists (busy_ctx, free_ctx, free_chunks) and one…

Published Oct 13, 2026 · catalog updated Oct 14, 2026 · the affected product

Check if you run it

No confirmed exploitation is on record for CVE-2026-19936. EPSS is 0.14%. Act only if a listed version of the affected product is installed.

Severity

Medium4.8

Known exploitation

Not in CISA/VulnCheck KEV

EPSS

0.14%

Remediation

Advisory link

Affected products

See sources for product scope

The Bluetooth Mesh Access-layer delayable message queue in subsys/bluetooth/mesh/delayable_msg.c shares three intrusive lists (busy_ctx, free_ctx, free_chunks) and one k_work_delayable between two cooperative threads with no synchronization: bt_mesh_delayable_msg_manage() runs on the Bluetooth host RX thread, while delayable_msg_handler() runs on the system workqueue. Both block while the lists are in an intermediate state — the enqueuer in bt_rand(), both in bt_mesh_access_send() — which lets the other context observe torn state. delayable_msg_handler() used the result of sys_slist_get() on busy_ctx without a NULL check, and allocate_delayable_msg_ctx() tested sys_slist_is_empty() and then assumed a separate sys_slist_get() would succeed. Because CONFIG_BT_MESH_ACCESS_DELAYABLE_MSG and CONFIG_BT_MESH_ACCESS_DELAYABLE_MSG_CTX_ENABLED default to y, every model response to a received mesh message is parked on this queue, so the enqueuer runs as a direct consequence of inbound traffic. A peer that can get access-layer messages accepted by a model (it must hold the NetKey and a bound AppKey, so a legitimate or compromised network member) controls the arrival rate, the size of the elicited responses and the destination address, and thereby controls occupancy of the 4-entry context pool and the 40-entry chunk pool. Exhausting the chunk pool forces bt_mesh_delayable_msg_manage() down the purge path, which sends and releases the only queued message and leaves busy_ctx empty while the delayable work item is still armed; if the enqueuer then yields, the handler runs against the empty list. The result is a read-modify-write through a NULL-based pointer (pending_msg->fired_time += 10) at a fixed low address on the system workqueue thread. On typical targets that faults, aborting the system workqueue thread — which stops all workqueue-driven functionality, including the mesh timing machinery — or resetting the node, so the impact is loss of availability of the affected node. The

No affected version ranges are stored yet. Use the vendor advisory before you decide this record does not apply.