Vulnerabilities

Vulnerability · CVE-2026-43118

In the Linux kernel, the following vulnerability has been resolved: btrfs: fix zero size inode with non-zero size after log replay When logging that an inode exists, a…

Published May 6, 2026 · catalog updated Jun 17, 2026 · linux kernel

Check if you run it

No confirmed exploitation is on record for CVE-2026-43118. EPSS is 0.16%. Act only if a listed version of linux kernel is installed.

Severity

Medium5.5

Known exploitation

Not in CISA/VulnCheck KEV

EPSS

0.16%

Remediation

Advisory link

Affected products

cpe linux/linux kernel

In the Linux kernel, the following vulnerability has been resolved: btrfs: fix zero size inode with non-zero size after log replay When logging that an inode exists, as part of logging a new name or logging new dir entries for a directory, we always set the generation of the logged inode item to 0. This is to signal during log replay (in overwrite_item()), that we should not set the i_size since we only logged that an inode exists, so the i_size of the inode in the subvolume tree must be preserved (as when we log new names or that an inode exists, we don't log extents). This works fine except when we have already logged an inode in full mode or it's the first time we are logging an inode created in a past transaction, that inode has a new i_size of 0 and then we log a new name for the inode (due to a new hardlink or a rename), in which case we log an i_size of 0 for the inode and a generation of 0, which causes the log replay code to not update the inode's i_size to 0 (in overwrite_item()). An example scenario: mkdir /mnt/dir xfs_io -f -c "pwrite 0 64K" /mnt/dir/foo sync xfs_io -c "truncate 0" -c "fsync" /mnt/dir/foo ln /mnt/dir/foo /mnt/dir/bar xfs_io -c "fsync" /mnt/dir After log replay the file remains with a size of 64K. This is because when we first log the inode, when we fsync file foo, we log its current i_size of 0, and then when we create a hard link we log again the inode in exists mode (LOG_INODE_EXISTS) but we set a generation of 0 for the inode item we add to the log tree, so during log replay overwrite_item() sees that the generation is 0 and i_size is 0 so we skip updating the inode's i_size from 64K to 0. Fix this by making sure at fill_inode_item() we always log the real generation of the inode if it was logged in the current transaction with the i_size we logged before. Also if an inode created in a previous transaction is logged in exists mode only, make sure we log the i_size stored in the inode item located from the commit root, so that if we lo