Vulnerabilities

Vulnerability · CVE-2026-89894

media: cx231xx: reject geometry changes while the VBI queue is busy

Published Sep 16, 2026 · catalog updated Oct 15, 2026 · media: cx231xx: reject geometry

Check if you run it

No confirmed exploitation is on record for CVE-2026-89894. EPSS is 0.16%. Act only if a listed version of media: cx231xx: reject geometry is installed.

Severity

High7.8

Known exploitation

Not in CISA/VulnCheck KEV

EPSS

0.16%

Remediation

Not established

Affected products

Linux Kernel

In the Linux kernel, the following vulnerability has been resolved: media: cx231xx: reject geometry changes while the VBI queue is busy vidioc_s_fmt_vid_cap() and vidioc_s_std() change the device-wide dev->width / dev->norm but only refuse the change when the *video* queue (dev->vidq) is busy. The VBI queue (dev->vbiq) shares that same geometry: cx231xx_init_vbi_isoc() latches dma_q->lines_per_field from dev->norm, the VBI videobuf2 plane is sized from dev->width / dev->norm in vbi_queue_setup() and vbi_buf_prepare(), and cx231xx_do_vbi_copy() then recomputes the destination offset from the *live* dev->width and the latched lines_per_field on every URB completion: offset = lines_completed * (dev->width current_field == 2) offset += dev->width * 2 * dma_q->lines_per_field; memcpy(plane + offset, p_buffer, lencopy); Because the VBI node shares video_ioctl_ops with the video node, an application can size a small VBI plane (REQBUFS/QBUF with a small width, or with the NTSC standard), then enlarge dev->width (or switch dev->norm to PAL) through the video node while the VBI stream is running -- the change is allowed because only dev->vidq is checked -- and let the device deliver a field-2 VBI payload. cx231xx_do_vbi_copy() now computes the offset with the larger geometry and memcpy()s past the end of the smaller plane that was already allocated, a heap out-of-bounds write whose offset is attacker-chosen and whose contents come from the device. The per-field guard in cx231xx_copy_vbi_line() does not help: it bounds the copy against the latched lines_per_field, not the plane's real capacity, and vb2 does not re-run buf_prepare() for an already prepared buffer. Refuse the format/standard change when the VBI queue is busy as well, so the geometry cannot change underneath an allocated VBI buffer.